twall Premium64, User Manual

Page: 13 / 40

t wall
®
Premium64 standard Color mobile / stationary User manual | Rev. 1.0.3
E| 13
Step
12
Shove the shield
A2b
into the
front lead channel between the side supports
down to the long frame profile
A2c
.
(fig. 3.1-19)
.
The shield (8 mm | 0.32 inch) should click
exactly into the lead channel of the frame
profile.
Step
13
Then insert another long frame
profile
A2c
into the front lead channel
between the side supports and move it down
to the shield
A2b
which should click into the
lead channel at the top.
The cross pieces of the profile connectors
should point backwards again. Please tighten
the profile connectors (ca. 25Nm).
II. Attaching the profile angles to the
frame profiles:
Step
14
:
In order to attach the profile
angles
A2e
, you will need sixteen (16) fillister
head screws with flange
M6x14
(2 per angle)
and sixteen (16) T-nuts
M6
. Measure the
long frame profile
A2c
which you have just
mounted to the shield. There are
930 mm
| 38.07 inch
from to inner edge of the side
supports to the middle of the screws the
profile angles will be screwed on with. Now
place two (2) Tnuts in the upper lead channel
of the long frame profile. Insert the T-nuts by
half-twisting them into the lead channels with
the swivel ball ahead and align them appropri-
ately
(fig. 3.1-20)
. Now insert two (2) T-nuts
into the lead channels of the short frame
profile
A2d
,1 x at the bottom left and 1 x at
the bottom right. There are
967 mm |
38.07 inch
from the inner edge of the side
supports to the middle of the lead channel.
Place the short frame profile
A2d
in the
middle of the long frame profile
A2c
and
attach the profile angles
A2e
, one to each
side using the fillister head screws with flange
(fig. 3.1-21)
. Tighten it properly with the
corresponding Allen key.
Step
15
Insert two (2) T-nuts into the
just assembled short frame profile again,
this time 1 x at the top left and 1 x at the
top right. Afterwards shove the long framel
profile A2c with the pre-assembled
PVC installation channel
into the front
lead channel between the side supports, move
it down until it seats on the vertically placed
short frame profile. The PVC installation
channel should point backwards. Now insert
two (2) T-nuts into the lower leading channel
of the long frame profile and align them as
follows: From each side measure a distance of
fig. 3.1-22
fig. 3.1-19
fig. 3.1-21 fig. 3.1-20
930 mm
967 mm