LCD Rack Mountable Monitor 31
• Scan (Not supported in RKM-535A)
- Controls th SCAN mode.
- Scrolling the Knob to change the sca mode.
- Available modes are [Zero Scan] -> [Over Scan]
-> [Pixel-To-Pixel] -> [User Aspect]
- User can set the Horizontal and Vertical size
of the screen
* Check “7. Other Functions [1] User Aspect” for
more information.
• Aspect
- Controls the display ratio.
- Available modes are[16:9][4:3][2.35:1][1.85:1]
[15:9][16:10][Auto].
- In [Auto] mode, display ratio will be changed
to the input ratio automatically.
• H/V Delay
- Used to check horizontal sync and vertical
sync simultaneously by moving the display
left, right, up and down.
- In this mode, the brightness of the image
automatically increase for easy verification of
synchronized signals.
• Blue Only
- Used to activate MONO mode or remove red
and green from the input signal and display
the screen only under a blue signal.
- Activates in the order : [Off]-[Blue Only]-
[Mono]-[Off]
• User Aspect Horizontal
- Used to set the Horizontal size of the screen.
- Activates only when the SCAN mode is set to
USER ASPECT.
• User Aspect Vertical
- Used to set the Vertical size of the screen.
- Activates only when the SCAN mode is set to
USER ASPECT.
• TimeCode
- Used to set the time code among Off, VITC
and LTC.
• 3G Format(SDI Only)
- Used to select 3G-SDI A/B input format
among Normal Mode (Auto : A422
10Bit_YCbCr. 50/60p), A 444 10/12Bit_YCbCr,
A 444 10/12Bit_RGB, A 422 12Bit_YCbCr, B
444 10/12Bit_YCbCr, B 444 10/12Bit_RGB, B
422 12Bit_YCbCr, B 422 10Bit_YCbCr 50/60p.
- In NORMAL MODE, the signal is automatically
detected when Payload signal is contained.
* In the HDMI mode, this function is not
supported.
[7] Display & Set
5. Menu Operations
