Page 13
Troubleshooting chart
The incubator does not start.
The incubator gives an error in
one position during “Autotest”.
The incubator gives an error in
the “Autotest”.
The incubator does not run a BI
reading.
The red light of that position is
blinking.
The incubator does not run a BI
readout in any position.
The incubator does not allow
changing the incubation program.
The printer does not print and
Attention indicator light blinks
quickly.
The printer releases unprinted
paper.
Power source is not connected.
A BI is placed in the position at the
moment of starting the incubator.
Dust particles might be
obstructing the light path
between the sensors.
The “Autotest” gives an error in
that position, which becomes
disabled.
The incubation temperature is not
stable.
Ongoing reading.
The printer cover is not tightly locked.
Printer without paper.
Paper roll is placed in the wrong
direction.
Check that the power source is
connected to the power supply
according to its characteristics and that
the plug is connected to the incubator.
Check that every position is empty at
the moment of starting the incubator.
Ensure cleanliness of the incubation
position. Use of air is recommended.
Do not use solid objects that could
damage internal components. Restart
the incubator.
Make sure that the position is empty
when starting the incubator. Restart the
incubator.
Wait for temperature to be stable.
Wait for the reading of corresponding
position to finish.
Check that the cover is tightly closed.
Place a new paper roll in the right direction.
Check the paper roll direction.
Fault
Possible cause
Action