Page 12
This functionality allows changing the language in which
the incubator printer renders the tickets.
To make this change, the device must be started in Setup
mode (see
Setup Mode
), then press the button .
The current language and list of available languages will
be printed to establish a reference. Press the button
to scroll up and
to scroll down. After 2 seconds, a
ticket will be printed informing the selected language.
To confirm the change, press and hold the button
for
3 seconds. To discard the change, unplug the incubator
from the power source.
Instructions for use
Setup Mode
Modification of time zone
Modification of printing language
The auto-reader has a setup mode from which, the device
time zone and the print language can be set up. To enter
Setup mode, turn on the incubator while holding down
the button
. The red and green LEDs in the three
positions will remain on, indicating that the device is in
this mode. The printer will render a ticket indicating that
it is in Setup Mode.
To change the time zone and the print language, follow
the instructions below. When finished, restart the
incubator to exit Setup mode.
Time setting mode
Change the time using the firmware update utility
Connect the auto-reader via the USB port to a PC and
start-up the program. Select the Auto-reader and
press the Clock Sync button, the auto-reader will be
synchronized with the PC’s clock. Synchronization can
only be done as long as there is not an ongoing reading.
firmware version available for the auto-reader; downloads
it and installs it in a few seconds without the loss of any
device data.
Update procedure
Before starting the process, turn off the incubator for five
seconds, then turn it on and follow these steps:
1-Connect the incubator to a PC using a USB cable and
make sure to have an internet connection.
2-Open the firmware update utility.
3-Select the device and press Start button to update.
4- Wait until the software indicates that the upgrade process
is complete. The auto-reader prints an update confirmation
ticket. If it was already up to date, it will print nothing.
NOTE:
This process must be repeated every time a new
firmware version is available, this will be informed in the
website.
The time zone modification function allows changing the
time zone of the device to suit the time zone of your country.
To make this change, the incubator must be started in
Setup mode (see
Setup Mode
), then press the
button.
The current time will be printed to set a reference.
To subtract hours, press the button
as many times as
necessary. To add hours, press the button
as many
times as necessary. After 2 seconds, a ticket will be printed
informing the selected time.
To confirm the change hold down the button for
3 seconds. To discard the changes, unplug the incubator
from the power source.