Page 46 of 56 Pages
When the door is properly closed, open door symbol
is replaced
by the message "System Ready" and the following screen will be
displayed:
8.7
Starting cycle
1. Start the cycle by pressing the START/STOP key.
The autoclave starts performing sequence of operations. The actual
measured values of pressure and temperature are displayed
continuously and printed every minute at
STE
stage, and every 5
minutes at the other stages. The phase in progress is displayed at the
right side of the upper line as
WATER
,
HEAT
,
STER
.,
EXH
., and
DRY
.
If the operator presses the
START
key and the door is not completely
closed, the process will not start and the
DOOR
indicator will flash
twice then turn off and the buzzer will sound four times.
Caution!
Do not touch the strainer’s cover, mounted on the exhaust line,
during and short after operation.
Touching the hot strainer’s cover may cause severe injuries.
