8
7. Regular Maintenance
1) The housing of the equipment is of a sub-polish stainless steel. It is required to clean
regularly with soft cloth so as to keep a clean and polish surface. It is forbidden to
clean the surface with a hard object; otherwise, the appearance may be affected. It is
also forbidden to wash it with water, otherwise, short circuit may occur in the electric
control system and the equipment may be damaged.
2) It is required to check regularly the connection of various movement sections of the
equipment. Fasten timely the loose fasteners such as nut and screw; otherwise, turnstile
failure may be resulted due to long term operation.
3) It is required to check regularly the protection grounding of the system to ensure a
reliable connection.
4) It is required to check regularly the connectors and line connection points to ensure a
reliable connection.
8 Common Failures and the Remedy
1) No indication for direction and counter, and not able to read card after power on.
The failure is due to power system. It is required to check carefully the 5A fuse in the
main board of the equipment (refer to Attached Figure 3, Appendix A.2) for damage,
and see if there exists any loose connector, and broken power line.
2) Not available to read card normally.
The failure is mainly due to a loose connection between reading device and the main
controller or the reading device may be damaged. Replace the reading device and carry
out functional test for it
Appendix A
A.1 Software manual
Login
Click the cmoloturnstile.exe it will open up the Login windows, as follows in attached figure 1:
