D301171 - IO-Link master 1108
3-21
Parameterization
3
Parameters of slots 2 to 5, IO-Link device module (IOLDM)
Generic IO-Link devices
Note
The parameters for the IO-Link device modules (slot 2 to slot 5) always depend on
the connected device.
Note
Sensors which are not part of the IO-Link master’s GSD-file (e.g. sensors from 3rd-
party-manufaturers) are treated as generic IO-Link devices.
Please observe, that the selected data width in the hardware configurator has to be
≥
the process data width of the connected device.
→
Table 12:
Parameters of
the generic IO-
Link devices
Parameter name
Value/ Meaning
A
default
setting
Identification
00 = any device
A
The data width of the connected sensor has to match the
data width of the configured one. In addition to that, the
cylce time for the cycle modes "fixed value" and "synchro-
nous" has to be
≥
the devices minimum cycle time .
10 = same device type
The connected sensor has to be the same as the config-
ured one. Vendor- and device-ID have to match.
vendor
0
A
to 32767
Enter the vendor-ID for the connected sensor
(TURCK e. g. 317).
device-ID 1
to
device-ID 3
0
A
to 255
Enter the device-ID for the connected sensor.
The following parameters describe the IO-Link index 1 (subindex 1 to 12), which, in prin-
ciple, hass to be supported by all IO-Link devices. If this index is used for the sensors’
parameterization or not, depends on the respective sensor. Please find the meaning of the
subindices in the documentaion for the respective sensor.
parametrization IO-Link
Index 1
Defines whether (and if yes, which) parameter settings from
"parameter in subindex 1" to "parameter in subindex 12"
should be downloaded to the connected device.
0000 = inactive
A
0001 = write subindex 1
0010 = write subindex 1 to 2
...
1100 = write subindex 1 to 12