Page 7 of 20
Turbovex A/S
Industrivej 45, DK – 9600 Aars
Telefon: +45 96 98 14 62 – Fax: +45 98 96 42 24
e-mail:
–
www.turbovex.dk
4.4.0 Installing the unit (standard mounting brackets)
Perform measurements and determine the placement
of the unit and drill a small center hole vertically
through the roof. Use the aforementioned template to
make the rest of the hole for the unit according to the
incline of the roof.
The mounting brackets are mounted between the
purlins at a distance of 1000 mm between the two
brackets. The mounting brackets are secured using
mounting screws top and bottom.
The forks on the bracket are adjusted so they are
directly opposite and locked in place using self-
tapping screws through in the telescopic tubes.
The unit, weighing about 200 kg. is mounted in the
brackets so the studs fall into place in the saddle
brackets.
When installing on a slanted roof, please place the
unit so the service hatch is facing the ridge of the roof
to allow for easy access to the hatch.
The unit can be lifted using the two lifting studs
mounted near the top of the unit.
Selftapping screw
HexHead screw
Lifting studs
