Turbosol GIOTTO MONO, Use And Maintenance Manual

Page: 29 / 46

USE AND OPERATION
7
561379 - IS16/02 - EN
29/46
7.5 MACHINE SWITCH-ON
Use safety gloves to protect against cuts and abrasions and safety goggles that fully protect the eyes, with
anti-fog shatterproof lenses.
The gun must never be directed towards the operator or other people.
Start the machine by turning the main disconnecting switch ON: the BLUE indicator lights up. This indicates the correct power
supply voltage: with correct voltage the light stays on.
If at start-up the indicator switches off, this means there is not enough voltage.
Make sure the supply line has been properly prepared (cable section and construction site’s electrical control board power
supply).
Activate the compressor’s switch (FIG.22-REF.1).
1
FIG.22
When the main disconnecting switch is ON, the following come one:
- the red indicator (signals anomalies),
- the blue line presence indicator if the line voltage is sufficient,
- the compressor starts working.
- the green water pressure presence indicator lights up when there is enough pressure in the water system, if water is supplied
from a drum the green indicator lights up only with the water pump inserted.
Pour the contents of a bag of ready-mixed plaster into the hopper in order to carry out the first adjustments for spraying.
Disconnect the hose (FIG.23-REF.2) the delivers the water to the mixing chamber by pressing and holding the water
supplement button (FIG.20-REF.8).
Adjust the flow meter (FIG.23-REF.4) to 500 l/h with the cock (FIG.23-REF.1) and then reconnect the hose (FIG.23-REF.2).
Press the water supplement button for about 3 seconds (FIG.20-REF.8).
When the green button of the start switch is pressed (FIG.20-REF.2) the material pump activates and the red indicator switches
off.