Turbosol GIOTTO MONO, Use And Maintenance Manual

Page: 24 / 46

6
SAFETY
24/46
561379 - IS16/02 - EN
6.4 RESIDUE RISKS
Following the instructions and recommendations contained in this manual allows you to use the machine properly and reduce
residual risks.
IN PARTICULAR:
Read the use and maintenance manual before commissioning the machine.
The operators at the machine and in the material unloading area must be trained to properly carry out the operations contained
in this manual.
Carry out all maintenance operations in "machine off" status.
PARTS UNDER PRESSURE:
Make sure and guarantee that the hose is structurally intact.
Make sure all of the hoses’ quick couplings and joints are tightened properly.
Do not disconnect the fittings when the hose is under pressure.
HOT PARTS:
Do not touch the gear motor, compressor or water pump when GIOTTO is in operation or within an hour after it has been
switched off.
MOVING PARTS:
Do not put foreign objects through the protection grid when the dispenser is moving.
Do not use the machine without the delivery flange and pump properly installed.
Do not open the gear motor support while the machine is in operation.
Do not use the machine without the protection grid or sleeve properly assembled and fitted.
ELECTRICAL PARTS:
Never operate with the electrical control board open.
Do not direct intense water jets on the electrical control board or on the electrical sockets.
6.5 SAFETY WARNINGS
- The machine must never operate if the hose is not connected to the delivery flange and to the spray gun.
- Follow the instructions on how to position the machine before starting it up.
- Check the state of wear of the hoses and related joints daily, as there is a danger of explosion, projected material and cutting
should the hoses break or disconnect from the joints.
- Do not insert objects through the protection grid with the power supply connected, risk of severe impact.
- Do not use the machine with flammable materials or in explosive zones.
- Use extreme caution when walking near the transport piping as there may be sudden movements, risk of impacts and
tripping.
- Should the material get clogged inside the transport piping, follow the relevant instructions in the following manual.
- The machine operator must pay constant attention to what happens in the work area so as to be able to intervene promptly,
and in the event of an emergency stop the machine.