Turbosol GIOTTO MONO, Use And Maintenance Manual

Page: 34 / 46

7
USE AND OPERATION
34/46
561379 - IS16/02 - EN
1
1 1
2 2
3
FIG.33 FIG.34
Remove the material delivery flange (FIG.34-REF.2) and the pump (FIG.34-REF.3) by pulling the chocks (FIG.34-REF.1) from
the tie-rods.
- Mount a new pump
- Put the mixing unit back into its original position and block it.
Assembling the screw in the stator
Normally, the stator lasts half the time of the screw.
- Disassemble the pump from the machine (see above in the paragraph).
- Grip the pump and extract the screw (FIG.35).
- Grease the screw and the stator mouth with Vaseline (DO NOT USE MINERAL OILS AND GREASES, BUT ONLY
VASELINE).
- Partially insert the screw inside the flared mouth.
- Hit the pump (stator + screw partially inserted) repeatedly on a base that does not ruin the stator (e.g. a piece of wood)
(FIG.36).
D
FIG.35 FIG.36
7.8 IMPORTANT WARNINGS
The operator must be specifically trained to carry out this operation.
In particular, before opening a coupling, check the delivery flange pressure gauge to make sure there is no residual
pressure in the hoses and, in any case, when stepped on, the hoses must sag. Also make sure that there is no one