Installation
4
Installation Requirements
Unpacking
1. Remove all packaging and transit protection but leave
the protective plastic coating on the exterior stainless
steel panels until the legs are fitted.
2. Check the range and supplied parts for damage.
Report any damage immediately to the carrier and
distributor.
3. Check that the following parts have been supplied with
your range:-
4 x Leg Adjustable.
4. Report any deficiencies to the distributor who supplied
your range.
5. Securely fit the 4 legs supplied with
range, as follows:-.
a. Tilt the range over onto it’s
side.
b. Remove the screws from the
leg support plates.
c. Fit the legs supplied and secure
with the screws previously
removed.
d. Place the range upright onto its
legs and ensure that the legs
are adjusted to level the range.
6. Remove all protective plastic coating from the exterior
stainless steel panels.
7. Check that the available electrical supply is correct to
that shown on the Technical Data Plate located on the
front right hand side panel.
Refer to the ‘Specifications’ section, ‘Range
Specifications Tables’.
Location
1. Position the range in its approximate working position.
2. The unit should be positioned so that the control panel
and range shelves are easily reachable for loading and
unloading.
Clearances
To ensure correct ventilation for the motor and controls,
the following minimum installation clearances are to be
adhered to:-
Rear
25 mm / 1”.
Left-hand side
25 mm / 1”.
Right-hand side
25 mm / 1”.
CLEARANCE FROM SOURCE OF HEAT.
A minimum distance of 300mm (12”) from the
appliance sides is required.
Electrical Connection
Each range should be connected to an adequately
protected power supply and an isolation switch mounted
adjacent to, but not behind the range and must be readily
accessible to the operator. This switch must be clearly
marked and readily accessible in case of emergency.
Check the electricity supply is correct to as shown on the
Technical Data Plate on the side panel at the front right
hand corner of the range .
Electrical supply connection points for the range are located
at the rear of the appliance, approximately 135mm from
the right hand side and 487mm from the floor. (Refer to
the ‘Specifications’ section in this manual).
Oven:
Ensure that the oven is fitted with the appropriate power
cord and plug.
Important:
Installation shall comply with local electrical, health and safety requirements.
It is most important that this range is installed correctly and that range operation is correct before use.
If you have any questions regarding the proper installation and / or operation of this range, please contact your local
Turbofan distributor.
This range must be earthed / grounded.
If the supply cord is damaged, it must be replaced by a
suitably qualified person in order to avoid a hazard.
Warning
Important:
It is essential that the legs are fitted to the range to
ensure correct ventilation of the appliance. Failure to fit
the legs may cause the appliance to overheat and may
result in component failure.
Remove 4 screws and
use to secure Feet
Important:
This appliance is fitted with two separate single phase
electrical connections for oven and cooktop;
Oven - Is supplied with a 3 pin cordset fitted ready to
plug in.
Cooktop - Requires a separate single phase supply
connected to the unit.