Appendix 1 - Reversing the Oven Door
15
18. Remove Blanking Screw and Door Catch from front of
range and swap around (refer ‘Adjusting Door Catch’).
19. Fit door spacers removed at Item 13 previously, to
lower hinge pivot bolt.
Re-Fitting the Oven Door
Fit the Door.
1. Refit range door by locating
bottom of door onto bottom
hinge plate pivot bolt and
spacers.
2. Fit top of door into top hinge
plate and secure with top
pivot bolt.
Fit Inner Glass to Door.
NOTE: It is important to ensure that the inner glass
is fitted correctly and that the glass pivots at
hinge end of door and not at handle end.
3. Fit pivot spacer removed at Item 3 on previous page,
to the lower inner glass pivot and locate inner glass
lower pivot into position on inside of door.
4. Locate top pivot of inner glass
into top of door and secure in
position with inner glass
retaining clip.
5. Lift inner glass up onto
locking catch to lock glass
into position.
Top Door Pivot Bolt.
Blanking Screw
Door Catch
Inner Glass Locking Catch
Adjust Door for Correct Alignment.
Check alignment and operation of the door. Ensure that
the door is correctly aligned horizontally and vertically.
1. To align, slacken off upper
and lower hinge plates and
correctly align the door.
Re-tighten both hinge plates.
2. Check that the roller catch
correctly retains door in the
closed position.
3. To adjust, slightly loosen
screws securing roller catch
and close the door. The
roller catch will centralise
itself.
4. Open door and tighten roller
catch securing screws.
Adjusting Door Catch
If the door sealing requires adjustment, carry out the
following to adjust the door catch:-
1. Check that the door seals correctly when closed, by
placing a sheet of paper between the door and the
seal.
2. Close the door on the paper
and attempt to withdraw
paper by firmly tugging on
paper. The paper should just
pull out with some resistance
but without tearing.
3. To adjust door catch, loosen
locking nut on door catch:-
a. If paper withdraws easily,
screw the door catch
‘In’
by ½ a turn
and repeat the test above until
adjusted correctly.
b. If paper cannot be withdrawn and door springs
open,
screw the door catch
‘Out’
by ½ a turn
and
repeat the test above until adjusted correctly.
4. Tighten the locking nut on the door catch.
Screw and
Retaining Clip.
Locking Nut
Slacken these screws to adjust
door vertically - horizontally.