18
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: Before each use of your grill, inspect
the Grease Tray, Grease Tray Heat Shield and in-
side of the Grill Bowl to be sure there is no exces-
sive grease and debris buildup. Clean the Grease
Tray, Grease Tray Heat Shield and inside of the
Grill Bowl frequently to eliminate grease/debris
build-up and to prevent grease fires.
(for Model BTE3212(A,B)LP/NG & BTE3812BLP/NG)
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
-
-
Main Burner Electrode Check with the
assistance of another person, perform
this Electrode Check before proceeding.
Be sure all control knobs are set to "OFF"
and open the grill lid.
Have your assistant stand to the right of the
grill and look toward the front of the grill bowl.
Never
put your face inside the grill head.
Push and turn burner control knob to and
you will hear a "clicking" sound and your
assistant would see a tiny blue spark within
each gas collector box. If a spark is present,
the electrode tips are properly positioned.
If no spark is seen, the spark gap needs to
be adjusted as follows:
This test will ensure that the Spark Electrode
Tips are properly positioned so your grill lights
easily.
•
•
If the gap between the spark electrode tip
and receiver is more than 3/16" wide use
needle nose pliers to gently squeeze the
gas collector box to narrow gap.
Recheck the electrode again, if no "clicking"
sound is heard:
Rotisserie Burner Electrode Check
Push and turn rotisserie burner control knob
to . Look for spark between electrode tip
and spark receiver tip.
If you don't see a spark from the rotisserie
burner, adjust the gap between the electrode
tip and spark receiver tip to 3/16" wide.
Install Cooking Components
9
Place the flame tamer rack inside the grill
bowl Position it onto the lower ledge of the
bowl above the burners. Next, place the flame
tamers on the flame tamer rack. (See the
diagrams on right)
Place the cooking grids on the ledge above
the flame tamers.
Place the warming rack into the slots on grill
bowl side panels.
Warming Rack
Cooking Grids
Flame Tamer
Flame Tamer Rack
(for Model BTE2614(A,B)LP/NG )
Warming Rack
Cooking Grids
Flame Tamer
Flame Tamer Rack
(For BTE3212B: 4pcs)
(For BTE3812B: 5pcs)
7
8
9
