Tunturi pure run 10.1, User Manual

Page: 28 / 104

28
Owner
’s manual
•
Pure
ru
N 10.1
In here you can see the currently
installed software information only.
Press Back button to go back to settings
menu.
Quick Start
Open Quick Start by pressing the
“Quick start” button in main function bar.
Quick start will start a workout without
any preset settings as in Manual mode.
Adjusting tension levels needs to be
done manually, and there is no time limit
and ore heart rate limit set.
Maintenance
Belt and running Deck
Your treadmill uses a very high-efficient
low-friction bed. Performance is
maximized when the running deck is
kept as clean as possible. Use a soft,
damp cloth or paper towel to wipe the
edge of the belt and the area between
the belt edge and frame. Also reach as
far as practical directly under the belt
edge. This should be done once a month
to extend belt and running deck life. Use
water only - no cleaners or abrasives. A
mild soap and water solution along with
a nylon scrub brush will clean the top of
the textured belt. Allow the belt to dry
before using.
NOTe:
The Running belt is pre-waxed. Any
form lubrication will harm the
performance and durability of the
running belt.
Belt Dust
This occurs during normal break-in or
until the belt stabilizes. Wiping excess off
with a damp cloth will minimize buildup.
General Cleaning
Dirt, dust, and pet hair can block air
inlets and accumulate on the running
belt. On a monthly basis: vacuum
underneath your treadmill to prevent
buildup. Twice a year, you should
remove the black motor hood and
vacuum out dirt that may accumulate.
UNPLUG POWER CORD BEFORE
THIS TASK.
Belt adjustments:
Running belt Tension Adjustment -
Adjustment must be made from the rear
roller. The adjustment bolts are located
at the end of the step rails in the end
caps, as noted in diagram below.
Tighten the rear roller bolts (clockwise)
only enough to prevent slippage at the
front roller. Turn both running belt
tension adjustment bolts in increments of
1/4 turn each and inspect for proper
tension by walking on the belt at a low
speed, making sure the belt does not