Tunturi pure run 10.1, User Manual

Page: 14 / 104

14
Owner
’s manual
•
Pure
ru
N 10.1
NOTe
– If a part is missing, contact your dealer.
Assembly (fig. D)
WArNING
– Assemble the equipment in the given
order.
– Carry and move the equipment with at
least two persons.
CAuTION
– Place the equipment on a firm, level
surface.
– Place the equipment on a protective
base to prevent damage to the floor
surface.
– Allow at least 200 cm of clearance
behind the equipment, 100 cm in front
of the equipment and 100 cm on the
sides of the equipment.
▪ Refer to the illustrations for the correct
assembly of the equipment.
Master power switch
The equipment is equipped with a
master power switch to shut down the
equipment completely.
To start the equipment:
1. Insert the mains plug into the
equipment.
2. Insert the mains plug into the wall
socket.
3. Set the master power switch to the on
position.
To stop the equipment:
1. Set the mains power switch to the off
position.
2. Remove the mains plug from the wall
socket.
3. Remove the mains plug from the
equipment.
Safety key (fig. e)
The equipment is equipped with a safety
key that must be properly inserted into
the console to start the equipment. If you
remove the safety key from the console,
the equipment will stop immediately.
1. Insert the safety key into the slot in
the console.
2. Make sure that the clip of the safety
key is properly attached to your
clothing. Make sure that the clip
is not removed from your clothing
before the safety key is removed
from the console.
Circuit breaker
The equipment is equipped with a circuit
breaker that interrupts the circuit when
the electricity load is above the
maximum capacity. When this occurs,
the circuit breaker must be pressed.
WArNING
– Before pressing the circuit breaker,
remove the mains plug from the
equipment.
If the equipment shuts down, proceed as
follows to restart the equipment:
1. Remove the mains plug from the
equipment.
2. Press the circuit breaker to restart the
equipment.
3. Insert the mains plug into the
equipment.
Lubrication (fig. F)
The running belt must be checked for
lubrication once per 2 months, based on
the average use of 60 minutes per day.
WArNING
– Before lubrication, remove the mains
plug from the wall socket.
CAuTION
– Only lubricate the running belt if
necessary. If you apply too much
lubricant, the running belt will slip
easily due to lack of friction.
1. Stand steadily on the running belt.
2. Take hold of the front handlebar and
push the running belt with your feet
so that it slides back and forth. The
running belt must move smoothly and
evenly without making sound.
3. If the running belt does not move
smoothly and evenly or if the running
belt does not move at all, touch the
underside of the running belt with your
fingertips to check the lubrication: