10
OWNER’S MANUAL
•
PURE RUN 1.1
MALFUNCTIONS
NOTE!
Despite continuous quality control,
defects and malfunctions caused by
individual components may occur
in the equipment. In most cases it’s
unnecessary to take the whole device
in for repair, as it’s usually sufficient
to replace the defective part. Always
give the model, serial number of your
equipment and in case of malfunctions
also conditions of use, nature of
malfunction and any error code.
When you encounter unusual behavior
from the treadmill, simply turn the power
switch off, wait 1 minute and turn the
power switch on to reset the treadmill.
This should clear incidental errors and
ready the treadmill for normal operation
again. If after you have reset the
treadmill by turning the power switch off
and on again, and the treadmill is still not
operational, contact your local Tunturi
dealer for service.
If you require spare parts, always
give the model, serial number of your
equipment and the spare part number for
the part you need. The spare part list is
at the back of this man
ERROR CODES
The user interface will display
information about operational faults.
ERR1:
Speed sensor error. Unplug the electrical
cord from the wall outlet and from the
treadmill, wait 1 minute and turn the
power switch on again. If treadmill
recovers to normal operation, you may
continue to use the treadmill. Otherwise,
call the dealer for service.
ERR3:
Lift motor error. Unplug the electrical
cord from the wall outlet and from the
treadmill, wait 1 minute and turn the
power switch on again. If treadmill
recovers to normal operation, you may
continue to use the treadmill Otherwise,
call the dealer for service.
TROUBLE SHOOTING
TREADMILL WILL NOT START
1. Not plugged in.
Plug into suitable outlet
2. Safety key not attached correctly.
Insert safety key
3. Treadmill circuit breaker tripped.
Reset circuit break
4. On/Off switch not turned on.
Switch On/Off switch on
5. Auto Shut Down Time Out.
Unplug and replug power cord.
TREADMILL BELT SLIPPING
• Walking belt too loose
Check belt tension.
• Deck needs lubrication.
Check deck/ belt lubrication.
TREADMILL NOISY
• Loose hardware.
Tighten visible screws, nuts and
bolts.
• Motor straining.
Belt tension to high.
• Clicking sound – roller knocking.
Adjust rear rollers – check the
tension.
INACCURATE PULSE RATE -HAND-
• Too much hand movement.
Stand on side rails to obtain accurate
pulse reading.
• Palms too wet.
Dry palms.
• Gripping hand grips too tight.
Grip using moderate pressure
• Wearing rings.
• Remove all rings
• Deck needs lubrication
Check deck lubrication
INACCURATE HEART RATE -STRAP-
• Chest strap pick-ups not moist.
Moisten pick-ups on chest strap.
• Electronically interference.
Keep at least six feet away from TV,
computer and fluorescent lights.
• Strap battery power low.
Replace strap battery.
