Tunturi Pure ROW 8.1, Owner'S Manual

Page: 15 / 28

EN
ROW 8.1 15
Filling the tank with water
1. Remove the rubber tank plug rubber tank plug rubber tank plug rubber tank plug from the top of the tank.
2. Place a large bucket of water next to the rower and position the siphon with the rigid rigid rigid rigid
hose in the bucket hose in the bucket hose in the bucket hose in the bucket and the flexible hose into the tank flexible hose into the tank flexible hose into the tank flexible hose into the tank as shown. Make sure the small
breather valve on the top of the siphon is closed before filling.
NOTE NOTE NOTE NOTE
⇒
17 liters of water is required for maximum filling.
⇒
Where water quality is poor, we recommend using distilled water.
⇒
Putting the bucket higher than the tank will allow the siphon to "self-pump"
when adding water to the tank.
⇒
Consider using a towel under the bucket and water tank preventing stains
on the floor.
WARNING WARNING WARNING WARNING
⇒
Failure to set the adjuster handle to MAX
MAX MAX
MAX prior to filling the tank will cause
inaccurate fill levels and possible leakage.
3. Begin filling the tank by squeezing the siphon. Use the level gauge decal level gauge decal level gauge decal level gauge decal on the side
of the tank to measure volume of water in the tank.
4. After filling the tank to the desired water level, open the valve on the top of the si-
phon to allow excess water to escape.
5. Ensure that the tank plug tank plug tank plug tank plug is replaced once filling and water treatment procedures
are complete.