ig. 9
Next, attach the Decal Numbers 1-24 (#74) on the inside of the
electorized Uprights (#6)
. Center the number 24 with the top adjustment
ole of the
Selectorized Uprights (#6)
. A great way to make sure you don’t
ap any air bubbles under the decal is by using the wedge method. Press
he side of your index finger against the decal and as you slide your finger
own, with the other hand, slowly remove the rest of the backing off the de-
al.
Fig. 10
Slide one
Bar Safety (#5)
, in the position as shown above, ove
each one of the
Selectorized Uprights (#6)
. Be sure to pull the Turn Pu
Pin w/Knob (#72) as you perform this assembly.
ig. 11
Slide one
Bar Holder (#4)
, in the position as shown above, over
ach one of the
Selectorized Uprights (#6)
. Be sure to pull the Turn Pull
in w/Knob (#72) as you perform this assembly.
Fig. 12
Attach two
Triangular Corner Plates (#2)
to the front of the tw
Selectorized Uprights (#6)
, in the position as shown above, using four He
Head Cap Screws 1/2-13 X 4 1/4 (#12), eight Flat Washers SAE 1/2” (#10
and four Nylon Insert Lock Nuts 1/2-13 (#9).
Loosely Fasten:
Do not completely fasten this hardware assembl
at this time, as it will be completely fastened later in the assembl
process.
5
LOOSELY FASTEN
TDH 345 Half Cage Ensembl
