Fig. 42
Multiple starting exercise positions can be achieved by using th
Coil Chain as an extension to connect the Lat Bar to the Lat Cable with ou
loosing traveling range on the Weight Carriage.
Note:
Optional Cable Attachments can be utilized within the sam
manner, for example: Tricep Bar, D Handle, etc.
ig. 41
Insert two Hard Grips 1 X 6 (#56) onto each of the tube-ends of
he
Lat Bar (#50)
.
Note:
Use Windex or household glass cleaner for easy insertion of
the Hard Grips 1 X 6 (#56).
ext, mount the
Lat Bar (#50)
onto the
Lat Bar Holder (#55)
and affix it to
he
Lat Cable (#53)
, in the position as shown above, using one Snap Link
#22), one Shoulder Bolt 3/8 X 3/4 (#63), and one Nylon Insert Lock Nut
/16-18 (#66). Use the supplied Hex Key 3/16” (#81) and a 1/2” combina-
on wrench to fasten this assembly properly. Refer to
Fig. A
on page 18 for
urther illustration of this assembly.
Fig. 44
Using a rubber mallet, insert two Foot Roll Plastic End Cap
1” (#79) into each of the tube-ends of the
Foot Roll Tube (#77)
.
Next, insert the
Leg Hold Down Assembly
into the receptacle of the *
TMP
75 (Multi-Angular Bench)
. Use the L-Locking Pin (#80) to Adjust the
Le
Hold Down Assembly
to the desired height.
*
Assembly Instructions for the
TMP-75 (Multi-Angular Bench)
come in it
own box.
ig. 43
Locate the
Leg Hold-Down Tube (#76)
and, using a rubber mal-
et, insert two Plastic Insert Caps 1 3/4” Sq. (#71) into each of the tube-
nds.
Next, insert the
Foot Roll Tube (#77)
into the receptacle of the
Leg Hold-
Down Tube (#76)
, then insert two Foam Foot Rolls 7 X 4 X 1 (#78) over
ach of the tube-ends of the
Foot Roll Tube (#77)
, as shown above.
Note:
Use Windex or household glass cleaner for easy insertion of
the Foam Foot Rolls 7 X 4 X 1 (#78).
13
TDH 345 Half Cage Ensembl