Fig. 28
Insert the
Lat Cable (#53)
and a Nylon Pulley 4 1/2” Rd. (#20
Labeled A) into the pulley bracket located on the
Top Pulley Housing (#1
as shown, then secure the Nylon Pulley 4 1/2” Rd. (#20-Labeled A) int
place using one Hex Head Cap Screw 3/8-16 X 2 1/2 (#29), two Flat Wash
ers SAE 3/8” (#45), and one Nylon Insert Jam Lock Nut 3/8-16 (#46).
Note:
Refer to the Cable Mapping Diagram on page 18 for furthe
clarification of the
Lat Cable (#53)
routing.
Fig. 26
Next, insert the
Pec Dec Cable (#40)
through the pulley bracke
on the
Pec Dec Housing (#15)
and install one Nylon Pulley 4 1/2” Rd. (#20
Labeled J). Secure it into place using one Hex Head Cap Screw 3/8-16 X
3/4 (#30), two Flat Washers SAE 3/8” (#45), and one Nylon Insert Jam Loc
Nut 3/8-16 (#46). Repeat the same procedure to route and secure the
Pe
Dec Cable (#40)
through the pulley bracket on the opposite side of the
Pe
Dec Housing (#15).
Note:
The black boxed letters pointing to the pulleys are use
throughout this manual as reference to the Cable Mapping Diagram
on page 18 These black boxed letters will be primarily used for loca
ing certain pulleys during the cable routing process beginning wit
Fig. 26.
y
ig. 25
Begin routing the
Pec Dec Cable (#40)
by attaching it to the
Pec
ec Arm Rt. (#38)
using one Hex Head Cap Screw 3/8-16 X 1 (#47), two
lat Washers SAE 3/8” (#45), and one Nylon Insert Jam Lock Nut 3/8-16
#46). Repeat the same procedure to attach the
Pec Dec Cable (#40)
to
he
Pec Dec Arm Lt. (#38).
Note:
Refer to the Cable Mapping Diagram on page 18 for further
clarification of the
Pec Dec Cable (#40)
routing.
ig. 27
Next, insert one Nylon Pulley 4 1/2” Rd. (#20-Labeled H) and the
ec Dec Cable (#40)
into the
Pec Dec Floating Pulley Bracket (#22)
and
ecure them into place using one Hex Head Cap Screw 3/8-16 X 1 1/2
#70), two Steel Bumper Washers 3/8” (#58), and one Nylon Insert Jam
ock Nut 3/8-16 (#46).
ext, snap one Plastic Bumper End Cap (#57) over each Steel Bumper
Washer 3/8” (#58). Place the Plastic Bumper End Cap (#57) over one edge
f the Steel Bumper Washer 3/8” (#58) and use gentle pressure with the
humb to snap the Plastic Bumper End Cap (#57) into place.
Note:
Refer to the Exploded View Diagram and Cable Mapping Dia-
gram on page 18 for further clarification of this assembly.
9
TDH 345 Half Cage Ensembl
