FIG. 11
Locate the Selector Pin w/Coil (#66) and slide the ring over
the
Selector Bar (#7)
as shown above.
FIG. 12
Begin the routing of the
Weight Stack Cable (#39)
by
threading a Finished Hex Nut 1/2-13 (#62) and Inserting a Split Lock
Washer 1/2” (#63) to the Cable Hex Tap Bolt 1/2-13 X 3 (#61). Then,
thread the Cable Hex Tap Bolt 1/2-13 X 3 (#61) to the threaded
socket of the
Front Frame (#29)
.
Loosely Fasten:
Do not completely fasten this hardware as-
sembly at this time, as it will be completely fastened later in
the assembly process.
Note:
Refer to
Fig A
on fold-out page 10 for further detailed il-
lustration of this assembly.
FIG. 10
Adhere the Decal Weight Numbers (#67) to the Weight Plates
(#6) in the corresponding order. Begin with the 20 at the top, 30 next,
and so on.
6
67
67
Owner’s Manual: Assembly Instructions
4
66
29
61
FIG. 9
Secure the
Pec Dec Arms (#30, #31)
to the
Front Frame
(#29)
using two Hex Head Cap Screws 3/8-16 X 1 (#52), two Split
Lock Washers 3/8” (#56), and two Fender Washers 3/8 X 1 1/2 (#57).
SP-405 Pectoral Contractor
31
30
34
34
29
6
7
66
7
62
63
39
