Page 9
Step 52:
Spread glue with a popsicle stick
or similar tool
Step 51:
Open the right wing and apply
Gorilla glue to the entire opening as shown
Step 53:
Spray water on the remaining spar
piece and blot away excess moisture
Step 54:
Insert spar with the “pocket” facing
forward aligned to the foam edge as shown
Step 55:
Tape the right wing like the left half
and set it aside for the glue to cure.
Step 60:
Cut out the foam parts with a
hobby knife that has a
new SHARP blade
.
Step 59:
Apply the template to the foam
sheet
spray both
sides of the
longer end
up to the
marks near
the center
The 3rd mark
should be
even with the
foam
Step 56:
Gather parts and tools.
Step 57:
Cut the full size foam template
sheet as shown
Step 58:
Lightly spray the backside of the
template with 3M77
Make foam tail feathers
You’ll need : 5/16” foam sheet, medium CA, kicker
ruler, pencil, hobby knife, 3M77
balsa tri stock, carbon elevator tube
Robart hinges, template sheet
hand drill 1/16”, 1/8” and 5/32” bits
Keep the
parts group
together -- it
fits the foam
exactly in the
next steps
