Page 45
Step 375:
Make push rods like you did for
the rudder and elevator.
Step 374:
Install aileron horn as shown
Step 376:
Install push rod with Z bend as
shown.
Step 377:
Gather parts and tools
Step 378:
Locate the foam inner foam core
piece and slice 1/2” from the thickest end
Step 380:
Tape the servo wire to the left
wing bottom as shown
Step 379:
Mark 4” from the remaining end
as shown
Step 373:
Carefully slice into the foam to
make a slot for the horn.
Step 372:
Extend the mark to the length of
the aileron control horn
Make the slice
perp
endicular to both
the hinge line
AND the
aileron surface
DO NOT cut all the
way through the
aileron!
Note shape of horn
should mate perfectly
with the angled bevel
of the aileron.
Push the horn down so
it is even with the top
surface of the aileron.
Step 371:
Install aileron servo arm and mark
perpendicular location on aileron as shown
Glue wings to fuselage
You’ll need :Wings, Sumo Glue, Gorilla Glue
drafting square, dowels, masking tape
2(2) 18” servo wire extensions
24” long thin wire or similar, ruler
foam inner front core piece, knife
pencil, toothpicks, small pliers/hemostats
