Page 4
Step 5:
Carefully pry and push out the foam
center pieces from the wing parts as shown.
Step 4:
Carefully separate the wing pieces
from the foam block as shown
Step 3:
Save the 5/16” sheet and discard
the thin top foam sheet.
Step 2:
Locate the 5/16” sheet foam and
carefully peel it from the block.
Step 1:
Gather parts and tools.
Step 6:
You may discard the shucks and
notched pieces as shown.
Step 7:
Peel away the “spider webs” and
chunks left from the foam.
Step 8:
Break one of the front foam cavity
pieces as shown to make a “sanding block”
Step 10:
Gently sand the aileron pieces to
true the leading edges to make them straight.
Step 9:
Use the EPP sanding block to help
clean the foam of spider webs.
Prepare Foam Parts
You’ll need : Pre Sliced foam block
40 grit sandpaper on a block
straight edge at least 24” long
medium viscosity CA (
not
foam safe)
CA Accelerator
Careful not
to round the
“point” of
the leading
edge!
Don’t discard
any other
pieces! They
will be used
later
