Page 7
Step 49:
Apply white gorilla glue or quick
grip into center wing/fuse joint as shown.
Step 48:
Lay onto blocks upside down as
shown. Blocks should be taller than canopy.
Step 47:
Wipe away any glue which squirts out
with acetone and paper towel.
Step 46:
Work Spars into slots being careful
to center them along the span (other half too)
Repeat for
all wing
spars
We use
two
identical
radio
boxes
Step 45:
Apply white gorilla glue or quick
grip into wing slots
Work quickly for
this and the
following steps--
one wing at a time
Step 50:
Repeat for bottom side joints as
shown.
Step 41:
Obtain two identical large blocks
to use as supports during next steps
The styrofoam
packaging from
your radio
transmitter may
work well
(At least 6” tall)
Step 42:
Insert wings between spars guiding
them into the slices to locate the wings.
Step 43:
When satisfied with wing position,
tack glue wing front to fuselage where shown.
Step 44:
Tack glue rear of wing similarly.
This quickly locks
wing into position
for next steps
Use center marks
on fuse for correct
alignment
use medium CA
and kicker
