Page 23
Step 201:
Mark CG location 6-3/4” from LE
at wing root
Step 202:
Place battery on wing top left side
and move to balance on the marks.
Step 203:
With battery at balance position,
mark spot for battery lead to poke through
Step 208:
Cut scrap wood or plastic to act as
backer support as shown
Step 207:
Insert (two linked) velcro straps
through fuselage to hold battery.
Step 206:
Slice through fuselage above and
below battery edge locations as shown.
Step 205:
Mark center of battery as shown.
Step 204:
Make hole in wing to clear
battery connector if needed
Step 209:
Glue G10 beneath velcro as shown.
Adjust straps to reach around battery
Step 210:
Route, tuck, hide remaining wires
as desired.
A soft piece of foam
rubber may be
glued on the other
side between
fuselage and
battery to stop it
from sliding
piece should be
sized to fit between
slots in foam
This depends on
your battery
location
This depends on
your battery
location
