920.1020.15
16
•
Adjust the secondary telescopic arm to the prescribed length according to chart:
•
Before installing any portion of the door arm assembly, it is easiest to lay the arm out on a flat surface and
insert the secondary and primary arm into the sleeve as it will be when installed on the door:
o
Slide the short arms within the sleeve to obtain the prescribed "X" dimension.
o
Tighten the screws on the short arm that is connected to the door shoe.
o
Double-check the "X" dimension of the arm - this is the distance between the center of the hole at the
door shoe and the center of the hole at the pivot point of the primary arm (as shown).
o
Mark a pencil line at the edge of the sleeve where it overlaps the short arm that is connected to the
primary arm. This will make it easier when positioning the primary arm for final installation.
•
Attach the secondary arm mounting bracket to the door. The centerline of the bracket should be at 13-1/2” in
from the inside face of the hinge jamb when using butt hinges on the door, and 16” when using a center pivoted
door.
Reveal
Hinge Hung X Dim.
Center Pivot X Dim.
0"
13"
16"
1"
14"
17"
2"
15"
18"
3"
16"
19"
4"
17"
20"
5"
18"
21"
6"
19"
7"
20"
8"
21"
DEEPER REVEAL REQUIRES ARM EXTENSION