GRANDE BRIO 45, 50 & 55
OPERATING MANUAL
4
PREPARING THE MACHINE
4.1 Moving the packaged machine
The machine is contained in specific packing (box + two-way pallet to be lift up only on the longer side) with a platform so
that it can be moved by a fork-lift. The packaging dimensions are:
A. 1060 mm
B. 670 mm
C. 1100 mm
WARNING
- The fork lift or the transpallet have to pick up the pallet at the center, the item has to be moved very
carefully without crash and paying attention to lift it up over the reasonable height.
4.2 How to unpack the machine
1.
Cut the polyethylene straps with suitable cutters, paying attention to its elastic return.
2.
Pull the box up to extract the machine.
3.
Lift the handle (See chapter 6.8 Adjusting Handlebar) and, while holding the front of the machine, push forward until
the complete bypassing of the wheel block.
4.
Lower the machine from the pallet by using a sloping shelf.
5.
Store pallet and cardboard box for any further transportation needs.
4.3 Inserting the batteries
The batteries must be housed in the battery compartment below the recovery tank.
WARNING
– For the maintenance and daily recharging of the batteries, it is necessary to follow the instructions
provided by the manufacturer or its dealer. All installation and maintenance operations must be carried out by
specialized personnel. Do not smoke, do not approach naked flames, do not use emery wheels and welding
machines; however, do not cause sparks near the batteries. Do not draw power from the battery with temporary
clamps, sockets and contacts. Make sure that all connections (cable lugs, sockets, plugs, etc.) are always well
tightened and in good condition. Check the integrity of the battery modules.
When handling batteries, always wear the safety clothing required by specific regulations. In particular,
before carrying out any work on the batteries, remove any metallic item from hands, wrists and neck, eg.
rings, watch chains. Do not place tools or metal objects on top of the batteries.
When inserting the battery (Fig. 2):
1.
Release the 2 black plastic hoses
2.
Unhook the drain from the solution tank
3.
Slipoff ahead recovery tank
4.
Be sure that the batteries are of the right size.
5.
Place the batteries as in the diagram.
4.4 Connecting the battery connector
Connect the batteries poles with the cables (Fig. 3).
4.5 Recharge of the batteries
In order not to cause the risk of permanent damage to the batteries, one should at all costs avoid their complete discharge
and effect recharging within a few minutes after that the signal of discharged batteries appears.
WARNING
– To avoid permanent damage to the batteries, it is essential to avoid their complete discharge, and to
recharge them within a few minutes after the warning of low batteries. Recharge IMMEDIATELY after discharge: DO
NOT LEAVE THE BATTERIES, EVEN PARTIALLY, DISCHARGED.
For the maintenance and daily recharging of the batteries it is necessary to follow the instructions provided by the
manufacturer or its dealer. All installation and maintenance operations must be carried out by specialized personnel.
The battery recharging operations are to be carried out in well-ventilated places and far from heat sources. Do not
smoke, do not approach naked flames, do not use emery wheels and welding machines; however, do not cause sparks
near the batteries. Charge with the battery caps and sides open. Do not perform repairs on the batteries and the
machine while charging.
Summary of Contents for GRANDE BRIO 45
