Page
16
of
41
‘In
-
Band’ Control
To allow ‘In
-
Band’ control of the PAM1
-IP-3G and/or PAM2-IP-3G, you must first ensure that the
‘Module
Setup’, ‘Global Options Setup’ and ‘PTP Setup’ settings hav
e been made (see pages 10, 11 and 12 of this
manual for further information).
‘In
-
Band’ control allows an external control system to manage multicast subscriptions using the following
protocols:
2110 SFP Module
2022-6 SFP Module
Ember+
Ember+
NMOS IS04/05
Embrionix RESTful API
Embrionix RESTful API
To allow In-Band control, ensure that the
‘Under External Control’
Preset is loaded for the corresponding
SFP Module you wish to control, as follows:
From the
SVIP Main Menu
, navigate to
Stream Config.
1.
Push the rotary encoder to enter the
Stream Config
Menu
2.
SFP1 Module: -
The PAM2-IP-3G displays both the
type (e.g. 2110 or 2022-6) and the firmware version
number of the SFP Module currently inserted into SFP
Slot 1 of the PAM2-IP-3G. If no valid module is present,
the me
ssage ‘pending…’ will be displayed.
3.
SFP2 Module: -
The PAM2-IP-3G displays both the
type (e.g. 2110 or 2022-6) and the firmware version
number of the SFP Module currently inserted into SFP
Slot 2 of the PAM2-IP-3G. If no valid module is present,
the mes
sage ‘pending…’ will be displayed.
4.
Active SFP: -
The name of the currently active SFP
Module is shown. Use of the TAKE and UNDO buttons
provides manual switching between the Multicast Streams currently being subscribed to by SFP1
and SFP2.
5.
SFP1 Preset: -
The name of the 2110 Preset currently loaded into SFP Module # 1 is shown here.
Any one of the SVIP Presets can be manually selected and applied here using the TAKE option.
Please note, when loading a 2110 Preset into the Active SFP, the 2110 Essences associated with
that preset will be displayed immediately on the front panel of the PAM2-IP-3G.
6.
SFP2 Preset: -
The name of the 2110 Preset currently loaded into SFP Module # 2 is shown here.
Any one of the SVIP Presets can be manually selected and applied here using the TAKE option.
SVIP Main Menu
Stream Config
Preset Setup
SVIP is selected as the Input Source
SFP1 Signal OK
–
active SFP
No Module Detected in SFP2
Statistics
Module Setup
SVIP Input Selection
2110d v2.2
Under External Control
PTP Setup and Status
2110 Global Options Setup
System Idle
UNDO
TAKE
SFP1 Module
SFP2 Module
pending...
SFP2 Preset:
SFP1 Preset:
Under External Control
UNDO
TAKE
SFP1
UNDO
TAKE
Active SFP:
