Page
11
of
41
2110 Global Options Setup
1.
From the
SVIP Main Menu
, navigate to
Preset
Setup.
2.
Push the rotary encoder to enter the
SVIP
Preset
Setup Menu
3.
Select and enter the
2110 Global Options Setup
Menu
4.
Select the SFP Module you wish to configure (either
SFP1 or SFP2)
5.
Set the Video Standard, Sender Type (Narrow,
Narrow-Linear or Wide) and Multicast Filtering as
required.
6.
Once done, Select
Save
and push the rotary
encoder once to apply the changes.
7.
Repeat for the other SFP Module if required.
8.
Press the red button as shown on Page 8 of this
Quick Start Guide to exit the
2110 Global Options
Setup
Menu.
Note: Setting the ‘Line Offset’ parameter is best set once a
valid 2110 video essence has been subscribed to.
SVIP Main Menu
Stream Config
Preset Setup
SVIP is selected as the Input Source
SFP1 Signal OK
–
active SFP
No Module Detected in SFP2
Statistics
Module Setup
SVIP Preset Setup Menu
PTP Setup and Status
2110 Global Options Setup
Global Options Setup
2110 PTP Setup and Status
SVIP Presets
2110 Ancillary Essence Setup
2110 Audio Essence Setup
Video Essence Setup
SVIP Preset Setup Menu
PTP Setup and Status
2110 Global Options Setup
34
IP and Port
Target SFP:
Narrow
1080i
SFP 1
YCbCr 422
50
SAVE
UNDO
Video Std:
Sender Type:
Multicast Filters:
Line Offset:
