TSE PTV100/72, Owner'S Manual

Page: 338 / 480

saue
77
Series 90 Minor Repair 9
1. Remove the speed sensor by disconnecting the
electrical connector, loosening the lock nut, and
unscrewing the speed sensor from the pump or
motor housing.
2. Always install a new O-ring before installing the
sensor.
3. Reinstall the speed sensor (with lock nut and O-
ring) into the housing. Adjust the gap between the
sensor and the magnetic speed ring as instructed
in Sec. 8.4 and torque the sensor lock nut.
4. If a speed sensor is not installed, the housing plug
should be torqued as indicated in the accompany-
ing figure.
OR
11/16 in. hex wrench
Torque: 13 Nm (10 lbf•ft)
after adjustment
Housing Plug
1/4 in. int. hex wrench
Torque: 23 Nm (17 lbf•ft)
Speed Sensor
11/16 in. hex wrench
Torque: 13 Nm (10 lbf•ft)
after adjustment
Housing Plug
1/4 in. int. hex wrench
Torque: 23 Nm (17 lbf•ft)
OR
Speed Sensor
11/16 in. hex wrench
Torque: 13 Nm (10 lbf•ft)
after adjustment
Housing Plug
11⁄16 in. hex wrench
Torque: 37 Nm (27 lbf•ft)
OR
Speed Sensor
Typical Location of Speed Sensor - PV
Typical Location of Speed Sensor - MF
Typical Location of Speed Sensor - MV
9.6 Speed Sensor
90000857
90000858
90000859
CONTENTS