In principle, the jigsaw does not require any special maintenance or
service. However, periodic oiling of the blade guide roller will ensure its
longer durability.
Regularly check the condition of the screws securing the jigsaw housing
and foot. Tighten if necessary.
After work, it is recommended to blow over the ventilation holes and the
blade mount with compressed air. This will prevent damage to bearings,
remove dust blocking the supply of engine cooling air.
Clean the housing with a clean, damp cloth and a small amount of soap,
then wipe dry.
Do not use any cleaning agents or solvents; they can damage parts of the
device made of plastic.
Make sure that no water penetrates inside the device.
Visible dirt in the laser beam outlet should be carefully removed with a
cotton swab using a glass cleaning fluids.
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
information tags
:
The charger may be cleaned exclusively with use of a dry cloth.
TRANSPORTATION:
Store and transport the tool in its transport box to protect it against
humidity, dust penetration and small objects; remember to protect its
ventilation openings. Small objects after getting into the casing can
result in damage to the motor.
If the battery is removed for transport or storage, make sure the contacts
will not short circuit. Remove metal items such as screws, nails, clasps,
loose bits, wires, or metal filings from the case or transport container or
PROTECTION OF THE ENVIRONMENT:
otherwise prevent them from touching the battery.
NOTE:
The symbol nearby denotes that old equipment must
never be thrown away together with other waste (with the
MANUFACTURER:
penalty of a fine).
Hazardous components of electronic
PROFIX Co.Ltd.,
equipment may adversely affect the natural environment and
34
Marywilska Street,
human health.
03-228 Warsaw,
POLAND.
Each household may contribute to the recovery and reuse (recycling) of
This appliance is in conformity with national and European standards as
old machinery and equipment. Both in Poland and Europe a system for
well as with general safety guidelines.
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
NOTE:
In case of technical issues, contact an authorised technical service.
machinery and appliances. Moreover, general purpose collecting points
Any repairs are allowed to be carried out exclusively by qualified staff with
for such equipment are available.
use of original spare parts.
10
LASER RADIATION
DO NOT LOOK INTO THE BEAM
CLASS 2 LASER DEVICE
λ: 650 nm P
≤
1 mW
EN 60825-1:2014
«
»
Never dispose of batteries in water.
«Read this instruction before switching on the
power supply and starting the work.»
«
»
Never dispose of batteries in fire.
«
»
Protect the battery against heat, e. g., against
continuous intense sunlight.
«
»
For indoor use only
.
TROUBLESHOOTING GUIDE:
PROBLEM
POSSIBLE CAUSE
REMEDY
Irregularities of the motor
operation.
Worn carbon brushes of the motor. Have the brushes replaced at a service workshop.
The jigsaw does not work.
No power voltage, damaged
motor or the power trigger.
Check the battery status, recharge or replace with a new one when necessary.
When the problem persists hand over the tool for repair at a service workshop.
Please refer to the warranty sheet for addresses of authorized workshops.
Battery low.
Recharge the battery.
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.
This
instruction
manual
is
protected by copyright.
Copying it
without the written consent of PROFIX Co. Ltd. is prohibited.
