12
© TrynEx International 2013 (REV A) F51302C
A. Hardware. Torx
Screws, Counter-Sink
Washers, Snap Nuts.
B. Installation of snap
nut.
STEP 22
Install the belt cover.
STEP 23
Thread the Height Adjustment Knob into the Height Adjustment Mechanism: Put a lubricant on the threads. Push the threads through the
rubber bushing. Feel around for the hole in the mechanism. Push down to ensure the threads are lined up. Make sure the knob is standing
vertical. Begin tightening. Do not force the knob to tighten. Refer to “Adjusting Brush Height” for instructions to adjust the brush height.
FINISHED
Assembly Instructions
E. Set the brush at an
angle. Slip the cover
over the belt area and
back so the Snap Nuts
can be seen through the
holes in the cover.
C. Location of Snap
Nuts.
F. Put Torx Screws with
the Counter-Sink Wash-
ers through the mount-
ing holes on the cover
and thread into the snap
nuts. Tighten.
G. Tightening. T20.
D. Location of Snap
Nuts.
IMPORTANT
Now that assembly is finished, fill the motor with oil and fuel tank with unleaded gasoline. See Maintenance Instruc
-
tions in Owner’s Manual for oil-filling instructions.
