11
© TrynEx International 2013 (REV A) F51302C
Assembly Instructions
C. Put cap and washer
on the axle. Thread
on the other nut and
tighten, leaving approxi-
mately 3/4” (20 mm) of
threads at the end of
the axle.
B. Screw the nut onto
the axle.
D. Put the Axle with the
Cap, Washer and Right
Brush through the brush
transmission (centered
underneath the brush
cover).
G. Put the Left Brush on
– make sure the brush
is locked onto center
Cap-Gear.
H. Put the cap and
washer on the end.
Thread on the Locknut.
I. Tighten the locknut.
You will need two 19
mm wrenches.
E. Put the Axle with the
Cap, Washer and Brush
through the drive source
(centered underneath
the brush cover).
F. In the center, the tab
on the Cap-Gear should
fit the slot on the brush
cylinder.
TAB
SLOT
