TRUST SPYC@M 300S
4.
My DSC program will pop up.
5.
Select the photos you want to download and then click on transfer photos
button (Fig. 5, 2).
6.
The photos transferred from the camera will be seen in the left panel in the
collection then you can select the photo you want to add in.
11 Installing
camera
stand
1.
Place the stand on the table.
2.
Slightly push down camera holder onto the stand. (See Fig. 4)
12 Troubleshooting
Method
1. Read the solutions given below.
2. Check for up-to-date FAQ’s, drivers and instruction
!
Problem Cause
Possible
solution
The computer's USB port
is not working.
Check the settings of your USB
port. For more details, visit:
www.trust.com/customercare/h
elp/usb.
The camera has not been
connected to a USB port.
Connect the camera to a USB
port.
Windows does not
detect a new device
after connecting the
camera.
The camera has been
connected to a USB hub
which does not have a
power supply.
Connect the camera to a USB
hub which has a power supply
or to a USB port on your
computer.
The TRUST
SPYC@M 300S is
flagged with an
exclamation mark ‘!’
in the ‘Device
Manager’.
The camera has an IRQ
conflict with a different
device in your computer.
Make IRQ addresses free. See
also:
www.trust.com/customercare/h
elp/general.
The TRUST
SPYC@M 300S
does not work in
combination with
the TV / capture
card.
There is a conflict
between the camera and
the TV card.
Carry out the following.
1) Remove the TV Capture
card.
2) Install the SPYC@M 300S.
3) Install the TV capture card.
The batteries have been
inserted incorrectly.
Insert the batteries again (see
chapter 3).
The camera is turned off.
Turn the camera on.
The camera does
not do anything.
The batteries are empty.
Replace the batteries (see
chapter 3).
The camera does
not react, although
the batteries are
full.
The camera must be
reset.
Remove the USB cable and the
batteries for at least 5 minutes
to reset the camera. Reinsert
the batteries into the camera.
The camera should now work.
10
