Trust SPYC@M 300S, User Manual

Page: 7 / 16

TRUST SPYC@M 300S
2. Now press the exposure button.
The standard capacity now changes to 52 (“
Hi ”) or 209 (“ Lo ”) so that you can take
more photos.
3.
If you press the menu button until “ Ld ” is on the LCD screen and then again
on the exposure button, then the pictures will no longer be compressed.
4.10 Flicker rate setting
Your camera has a standard flicker rate setting. See Table 4.
1. Press the menu button until you get to “50” or “60”.
2. Either "50" or "60" is showing on the LCD screen, press exposure button.
Country UK Germany France Italy Spain Netherlands
Setting
50Hz 50Hz 60Hz 50Hz 50Hz 50Hz
Country Portugal Poland Greece Belgium USA
Setting 50Hz 50Hz 50Hz 50Hz 60Hz
Table 4
5 Deleting pictures
Note: If you don’t press the exposure button within five seconds, then the
camera will go back to the capacity mode.
5.1 Delete last photo
1.
Press the mode button until “ ” appears on the LCD screen.
2. Press on the exposure button again and you will hear a short beep indicating
that the last photo has been deleted.
5.2 Delete all photos
1. Press the mode button until “ ” appears on the LCD screen.
2. Now press the exposure button and the LCD screen will start flashing.
3.
Press on the exposure button again and you will hear a short beep indicating
that all photos have been deleted.
Note: By pressing the exposure button, you delete all the pictures. So be
careful when using this function.
6 Installing the camera
Before you can send photos from the camera across to the computer, you must install
the correct driver on your computer. Follow these instructions to perform the
installation.
6.1 Uninstalling old drivers and products
The most common cause of faults during installation is the presence of a driver for a
similar, old device. The best solution is to remove all drivers related to old devices
first, before installing the new driver. Make sure you only delete programs for old,
unused (similar) devices.
1.
Enter the Windows ‘Safe Mode’ (press F8 when starting Windows and then
select ‘Safe Mode’ from the menu which will be displayed).
2. Click on ‘Start – Settings – Control Panel’ and double-click on the
‘Add/Remove Programs’ icon.
4