90°
45°
Table Surface
Disc
Disc
Table Surface
Adjusting
Nut
Stopper
Blocking
Nut
Adjustments
11
• Loosen the blocking knob (
A
) and turn the control
flywheel (
B
) until the disc reaches the desired height.
• The disc teeth shall be 1/8” to 1/4” height above the
work piece surface.
• Tighten the blocking knob to keep the disc in the
selected height level.
• Loosen the blocking knob (
C
) and turn the control
flywheel (
D
) until the disc is in the angle you need.
• The disc can be adjusted from 90° to 45°
• Tighten the blocking knob to keep the disc in the chosen
angle.
• Before using the saw for the first time, make sure the 90°
and 45° are correct. Use a combination square set.
• If the event the degrees are not correct, adjust the
stoppers in the disc angle control mechanism inside the
cabinet.
• The adjustment shall be carried out loosening, outward
or inward, the blocking nut and then, the adjusting nut,
whatever is needed.
• Check the disk angle periodically to make the
adjustments if necessary.
Cutting Disc Height and Angle
• In the event that the guide is mounted and the blocking
lever (
E
) is down but not aligned with the table slots, lift
the blocking lever, disassemble the guide, set it with the
down side up and adjust the screws in the back (
F
).
• Pressure in the blocking lever can be adjusted turning
both knobs in a synchronized manner (
G
). Before turning,
loosen the blocking nuts.
• To adjust the guide perpendicular to the table, place a set
square (
H
) onto the table and against the guide side. Turn
the knobs (
I
) until the guide sits perpendicular to the
table. Before turning, loosen the blocking nuts.
• The pointer (
J
) can be adjusted when necessary to that
the red line will match the zero in the scale. Loosen the
two screws fixing it to the guide.
Guide
B
C
E
H
A
D
F
G
J
I
I
G
F
ENGLISH
