Start Up
Maintenance
10
• The rotary tool uses a high-grade lubricant. It ensures lubrication the tool’s full working life when used in regular
conditions. Does not need further lubrication.
• Inspect regularly all the mounting screws and double-check they are tightly secured. Loose screws present a high risk.
Service and repairs
• In the event the tool is not working properly go to an
Authorized Service Center.
• Service and repairs should only be made in a
Authorized Service Center. Service
and maintenance performed by non-qualified people may
be dangerous and can lead to personal injuries. It also
makes the product Warranty void.
• Use only original spare parts.
Otherwise there you may be exposed to accidents and
make the Warranty void.
Cleaning and Storage
• Do not use aggressive cleaning products, metal brushes,
sharp or metal utensils, otherwise the rotary tool housing
gets damaged.
• Clean the housing with a soft and dry cloth.
• Remove dirt with a humid cloth and mild detergent.
• Never submerge the rotary tool in water or other type
of liquids.
• Dry the rotary tool thoroughly before storing.
• Load the battery full before storing the rotary tool for
long periods of time. Storing unloaded batteries or
partially discharged may cause a deep discharge. This,
destroys the batteries cells and makes them useless.
• Store the rotary tool out of the reach of children. Keep
it in a locked placed with a storing temperature ranging
between 41 °F and 68 °F
ENGLISH
A
B
On/Off Switch
• To start the tool, press the on/off switch (
A
).
• To stop the tool, press the on/off switch again.
• This tool has been set to the slowest
speed before switching on.
Drilling Operation
• Turn the tool on to full speed. Apply the tool to the
workpiece gently.
Apply light pressure on the tool. Excessive
pressure will only cause a poor finish and overloading of
the motor.
Speed Adjustment
• To achieve the best result when working with different
materials, you can adjust the tool speed with the variable
speed control button. Press the “
+
” speed button to
increase the speed and press the “
-
” speed button to
decrease the speed.
• Select a low speed when working with wood, plastics
and polishing.
• The 5 blue speed indicators (
B
) indicate the 5 levels of
speed, the speed is corresponding from 5000 to 25000
RPM.
Holding the Tool
• For milling or engraving, hold the tool like a pen. Take
care not to cover the ventilation slots.
The tool will get warm during normal
operation. Observe the rated operating time.
CAUTION
CAUTION
CAUTION
Environmental protection
Power tools and batteries should not be disposed off together with household trash. Please deliver this tool and the
batteries to its adequate recycling in the authorized disposal sites. Verify the nearest recycling center in your community.
