Trumpf quicksharp, Operator'S Manual, Page: 14 / 95

• Swing the locating stop (4) to the left; a certain amount of
resistance must be overcome when doing so
• Lower the top until the locating stop rests on the die - then swing
the stop back to the right
• Close flap (6); the machine cannot be started with the flap open
• Set the desired regrind amount at the rotary knob (7)
• Main switch (9) ON
• First pull, then press the feed button (11)
• Grinding takes place automatically. The quicksharp switches off
automatically when the grinding process is finished.
Regrinding Multitool In preparation for grinding, Multitool dies must be raised and shimmed
dies in the die holder.
☞
Automatic grinding can be interrupted any time by pulling the
feed button (11).
As a visual aid, the green indicator pin (8) becomes visible at
the end of the automatic grinding cycle. The quicksharp
switches off automatically when the grinding process is
finished.
Suitable die clamping fixtures (see spare parts list) must be
used when sharpening dies from other manufacturers.
B60E
quicksharp
11