5055.549-A
TN10 NA 080617-28
21
The Chimney connector pipe should be disconnected from the wood stove to clean and inspect the chimney.
Only if this is not possible should you remove Baffle Board.
DO NOT OPERATE WITH BAFFLE BOARD INSULATION OR TUBES REMOVED.
Removal
1. With a set of vise-grips, grasp the front baffle tube on the right, slightly away from the baffle air assembly.
While squeezing tightly, use a hammer to hit the pliers and pull the tube to the right to disengage the tube
from the hole on the left. Allow the tube to hang freely from the hole on the right.
2. Repeat step #1 for second baffle tube.
3. Grasp the front edge of the left half of the baffle board and tilt up at the back. Guide the board down and
through the door opening.
Caution - Baffle Board material is very fragile.
4. Grasp the right half of the baffle board and slide it over to the left.
5. Tilt the back of the board up and guide it down and through the door opening.
6. Reverse the process to replace the baffle assembly.
Installation
1. Insert one half of baffle board above the two back baffle tubes inside the firebox, slide over to the right
and allow to rest on the baffle air assembly.
2. Ensure that the second half is inserted to allow the two cuts in the baffle boards to overlap. Insert the
other half of the baffle board and allow to rest on the left side baffle air assembly.
3. With the holes facing forward and the notch to the left side, insert a baffle tube into the hole in the baffle
air channel on the right at an angle and then raise and insert into the opposite hole on the left side baffle
air assembly.
4. With a set of vise-grips, grasp the baffle tube on the left, slightly away from the baffle air assembly. While
squeezing tightly, use a hammer to hit the pliers and push the tube to the left to engage the tube in the
hole on the left.
5. Repeat steps #3 & #4 with the remaining baffle tube.
6. Slide the baffle board halves together and then separate slightly to ensure there are no gaps on either side
of the baffle board.
7. Push baffle board tight against the rear of the firebox.
Baffle Board / Tube Installation