CHAPTER 5: CARE & MAINTENANCE
Truefitness.com / 800.426.6570 / 636.272.7100
132
RUNNING BELT ALIGNMENT:
Proper belt alignment allows the belt to remain centered and ensures smooth operation. Realigning the belt takes a few
simple adjustments. If you are unsure about this procedure, call the TRUE Service Department.
CAUTION
:
Special care must be taken when aligning the running belt. Turn off the treadmill while adjusting or working near the rear
roller. Remove any loose clothing and tie back your hair. Be very careful to keep your fingers and any other object clear of
the belt and rollers, especially in front of the roller and behind the deck. The treadmill will not stop immediately if an
object becomes caught in the belt or rollers.
CAUTION:
If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing
the STOP key. Contact the TRUE Service Department. Walk around to the rear of the unit and observe the belt for a few
minutes. The belt should be centered on the running deck. If the belt drifts off center, you must make adjustments.
Important:
Failure to align the belt may cause the belt to tear or fray, which may not be covered under the TRUE Fitness Warranty.
To stop the running belt, press the STOP key. Turn the treadmill off.
CAUTION:
For your safety, use the power switch to turn off the treadmill before making any adjustments. Do not adjust the running
belt when someone is standing on the unit.
CAUTION:
Do not turn the adjusting bolt more than ¼ turn at a time. Over tightening the bolt can damage the treadmill. If you are
unsure how to adjust the running belt, call the TRUE Service Department.
If the running belt is too far to the right side:
•
Locate the belt adjustment bolts in the rear end caps of the
treadmill. (To determine left and right, stand at the rear of the
treadmill and face the display).
•
Using the appropriate size Allen wrench or socket turn the
RIGHT adjustment bolt clockwise ¼ turn.
•
Turn the treadmill on and start the belt at 3mph keeping off
the unit.
•
Allow 2 minutes for the belt to adjust itself.
•
Repeat the above steps if additional adjustment is necessary.
