2
2
2
Clevis
Copper joiner
Aluminum tube(3x6mm)
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Aluminum tube
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
2
2
2
Clevis
Copper joiner
Aluminum tube(3x6mm)
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Aluminum tube
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
15mm
3mm
125mm
60mm
3mm
2
Plastic tube(3x50mm)
Steel wire
Aluminum tube
Clevis
Lock Nut (3mm )
Washer(3x15mm)
Screw (3x65mm)
Tail wheel
Assembly of the elevator servo.
Epoxy the plastic tube to relevant position in
the fuselage.
The position of the control horn in the rudder.
Connect the linkage and the horn on the rudder.
Assemble the rudder servo to appropriate position in
the fuselage.
Install the rudder servo.
10
55
54
53
50
52
51
3mm
C
C’
D
D’
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
C = C '
D = D '
2x7mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
4mm
4
1
Rib template (3mm ply)
2x7mm
Wood dowel (4x30mm)
Assembly of the stabilizer.
Drill holes to appropriate position in the stabilizer and
epoxy it to the fuselahe as below.
The sketh amp of the steel wires in the fuselage
Glue the elevator to the stabilizer by CA and epoxy.
Set the U-style wire through the tail of fuselage as
below.
According to the rib template drill holes to the stabilizer
and epoxy wooden dowels in them.
7
38
36
33
35
34
37
