Elevator
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
2
1
Steel wire (0.5x3000mm)
Steel wire (0.5x3000mm)
U-style wire (3mm)
Rudder
Vertical
fin
Cut away the rubber tube when
the epoxy glue dried.
1mm
Make sure they are in
the right position while
installing.
2.5mm
Make sure hinges are
mounted in the same line.
4mm
1
Rib template (3mm ply)
6
Pin hinge(24x24mm)
keep some space 1mm width between the vertical fin
and rudder
connect the fullarm for elevator with steel wire as
below.
Keep some space about 1mm width between the
elevator and horizontal tail edge.
Apply instant type CA glue to aileron and pin hinge.
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
According to the rib template drill holes in the
stabilizer root.
6
32
31
30
27
29
28
1
Nose arm(3mm)
Collar (3mm)
2
1
1
Tail landing gear(3mm)
Tail wheel (45mm)
Clevis
3
1
Retainer
Rod (2X257mm)
1
TP Screw(3x20mm)
Washer (3x6mm)
4
4
8
TP Screw (2.3x12mm)
Add a rubber ring to the
clevis for insuring safety
Throttle servo
Rudder servo
Elevator servo
Switch servo
8
Ply (15x15x10mm)
Assembly of the switch servo.
Assemble the switch servo to the fuselage.
The sketch map when the servos install completion.
Assemble the elevator servos to the fuselage.
The sketh amp of the steel wires in the fuselage
57
58
56
59
60
11
Accessory list for the coming installation steps.
