80 mm
24 mm
2
Wood dowel (6x50mm)
24 mm
80 mm
2
2
Blind Nut (6mm)
Screw(6x50mm)
1
Stab joiner (16x280mm)
4
4
2
2
Pin hinge(24x24mm)
Pin hinge(2.5x48mm)
Steel wire (0.5x3000mm)
1
1
U-style wire (3mm)
Nose arm
Nose arm
1
4
Tail landing gear(3mm)
Tail landing gear
Collar (3mm)
Collar
Ply (6mm)
2
1
4
Ply (6mm)
1
Washer (3X6mm)
4
4
Screw (3x15mm)
Screw (3x6mm)
Collar
13mm
Blind Nut (3mm)
Blind Nut (3mm)
4
Screw (3X15mm)
Screw (3x15mm)
Washer(3x6mm)
6mm
6.2mm
Blind Nut
4
Matal douel (4x30mm)
1
Rib template (3mm ply)
Drill two holes to the appropriate in the middle wing
and mount the dowels in them .
Drill two holes to relevant position in the fuselage
Mount the wings to the fuselage with screw .
Accessory list for the coming installation steps.
Assemble the tail landing gear to the wheel steeling
mounts as below.
Fix the nose arm to the ply with TP screw as below.
5
26
25
22
24
23
C
C’
D
D’
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
C = C '
D = D '
4
Blind Nut (4mm)
Engine mount (68x105mm)
Linkage Stopper
4
4
12
4
Washer(4x8mm)
Screw (4x35mm)
Spring Washer (4mm)
Nut (4mm)
2
4
Screw (4x25mm)
2
Fuel tank (550cc)
1
2
Clevis
In case of 2-cycle & 4-cycle engine.
155 mm
4
4
4
Clevis
Copper joiner
Aluminum tube(3x6mm)
4
4
Screw (2x10mm)
Nut (2mm )
2x7mm
2x7mm
3mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
4
Washer(2x5mm)
Assembly of the stabilizer.
The side view when the engine install completion.
The front view of the engine install completion.
Drill holes to appropriate position in the stabilizer and
epoxy it to the fuselahe as below.
Glue the elevator to the stabilizer by CA and epoxy.
8
43
42
40
39
41
Accessory list for the coming installation steps.
