: 120 - 4cycle
15
"
x7
Spinner nut
6
(with 8 servos),
6
6
6 channel radio for aiplane is highly recommended for this model.
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Apply epoxy glue.
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
Right view
Side View
30mm
30mm
RUDDER
25mm
25mm
AILERON
Side View
40mm
FLAP
AILERON
FLAP
TP Screw (2.3x12mm)
Wooden Block
TP Screw (2.6x14mm)
Collar (5mm)
Wooden supporter
7
TP Screw (2.3x6mm)
Ply (15x15x6mm)
7
Wooden Block(43x28x26mm)
1
Gear door
2
4
Collar (5mm)
Wheel (100mm)
Landing gear
2
1
8
2
TP Screw (3x20mm )
Landing gear straps
(5mm)
4
TP Screw (2.6x14mm)
2
Wooden Block(25x15x13mm)
1.5mm
Epoxy the fixed landing gear to the main wing.
Adjustment.
Adjustment.
Install the wheel to the fixed landing gear.
Epoxy plies under the canopy and assemble the
canopy to fuselage with screw.
13
71
69
70
67
68
Accessory list for the coming installation steps.
