4
Pin hinge(24x24mm)
Make sure hinges are
mounted in the same line.
35mm
Before
After
90º
48mm
85mm
2
Pin hinge(2.5x48mm)
Using rubber tubu cover
the middle of the hinges
before installation in case
the epoxy glue get into.
Make sure hinges are
mounted in the same line.
1mm
Rudder
Vertical
fin
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
3mm
2.5mm
Drill holes to appropriate position in the rudder and
epoxy the ping hinges in them.
Bend the gear steel wire as below.
Epoxy the ply to appropriate position inside the tail of
fuselage
Apply instant type CA glue to aileron and pin hinge.
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Keep some space about 1mm width between the
vertical fin and rudder.
6
32
31
30
27
29
28
Elevator
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
2
1
Steel wire (0.5x3000mm)
Steel wire (0.5x3000mm)
U-style wire (3mm)
4mm
4mm
4
Wood dowel (4x30mm)
1
Rib template (3mm ply)
The sketh map of the steel wires in the fuselage
Set the U-style wire through the tail of fuselage as
below.
connect the fullarm for elevator with steel wire as
below.
Keep some space about 1mm width between the
elevator and horizontal tail edge.
Drill two holes at the stabilizer root base on rib template
and epexy the metal dowel in them.
A ccording to thr rib template drill holes to the tail of
fuselage as below.
7
38
37
36
33
35
34
