29
MANTENIMIENTO
ADVERTENCIA:
Para evitar lesiones graves, nunca
realice el mantenimiento de la unidad mientras está en
funcionamiento. Desconecte siempre la batería para evitar
que la unidad arranque accidentalmente. Siempre debe
esperar que la unidad se enfríe antes de hacer el
mantenimiento. Antes de realizar el mantenimiento del
cargador de baterías, desenchufe siempre el mismo del
tomacorriente.
MANTENIMIENTO DEL CARGADOR DE BATERÍAS
•
Mantenga el cargador de baterías limpio y sin residuos. No
permita que ingresen materiales extraños en la base de carga ni
en los bornes (Fig. 10). Inspeccione el cargador de baterías para
ver si hay materiales extraños antes de usarlo.
•
Asegúrese de que el cargador no se haya cortocircuitado a
causa de residuos. Inspeccione los bornes para detectar hollín y
signos de fusión. No intente usar un cargador cortocircuitado.
Fig. 10
Bornes
Base de carga
USO DEL BOTÓN "BOOST" (REFUERZO)
Oprima el botón de refuerzo para cambiar entre los modos MAX y
ECO, según sea necesario (Fig. 9).
•
El modo
MAX
brinda la potencia máxima para trabajos pesados.
•
El modo
ECO
conserva energía para maximizar el tiempo de
funcionamiento. El modo ECO es adecuado para la mayoría de
los trabajos.
NOTA:
La unidad se restablecerá en el modo ECO unos segundos
después de apagar el motor.
Fig. 9
Botón “Boost”
(refuerzo)
•
Desplace la unidad de un lado al otro con el tubo del soplador
varias pulgadas por sobre el suelo. Avance lentamente,
manteniendo los desechos acumulados delante del operador.
•
Limpie al terminar la operación. Elimine los residuos correctamente.
•
Extraiga la batería de la unidad cuando no la use.