6
EN
dehumidifier TTK 165 ECO / TTK 170 ECO / TTK 380 ECO
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle and two wheels.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Do not incline the device by more than 45°, for otherwise
the device could be damaged.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
After having transported the device in horizontal position,
leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. Any warranty claims will be voided
in this case.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
TTK 165 ECO / TTK 170 ECO
•
1 x Device
•
1 x Air filter
•
2 x Transport wheel
•
1 x Axle
•
2 x Standard split pin
•
2 x Linchpin
•
4 x Washer
•
1 x Transport handle
•
2 x Foot
•
2 x Large screw
•
10 x Small screw
•
1 x Manual
TTK 380 ECO
•
1 x Device
•
1 x Transport handle
•
1 x Air filter
•
4 x Screw
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
