Trotec TES 200, Original Instructions Manual

Page: 13 / 27

EN 13 vertical heater TES 200
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
Warning of electrical voltage
Maintenance tasks and repair work may only be
performed by qualified electricians or Trotec.
Cleaning the housing
Clean the housing with a soft, damp and lint-free cloth. Ensure
that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Wipe the housing dry after cleaning.
Visual inspection of the inside of the device for dirt
1. Remove the air filter.
2. Use a torch to illuminate the openings of the device.
3. Check the inside of the device for dirt.
4. If you see a thick layer of dust, have the inside of the
device cleaned by a specialist company or by Trotec.
5. Put the air filter back in.
Changing the filter
The filter change intervals depend on the degree of air pollution
and the filter quality. Dirty filters impair the performance ability
of the electric heater. If the filter is contaminated to a certain
degree, a warning will be indicated on the display and a new
filter has to be inserted.
1. To do so, remove the air inlet with air filter (5) by folding
the holder out towards the front.
5
2. Remove the filter from the holder.
3. Insert the new air filter into the device.
Checking the safety temperature limiter
If the safety temperature limiter (10) has triggered, allow the
device to cool down. Then twist off the protective cap and press
the fusing into the device until it locks into place.
10